Posted on

Gotcha! – Los Angeles, CA (KLAX)

Los Angeles (KLAX) has a surprising gotcha when flying from an arrival and transitioning to an approach.  You should be very aware and know that they will issue an approach clearance while still on the arrival.  A terminating point on the arrival can also be the IAF on the approach.  Trouble is, the assigned runway may not be issued to you until that point and you really need to scramble to punch into the FMS the correct approach.  This can be a very high workload situation to those who are not expecting it and a few may even question its legality, but it is a perfectly acceptable clearance, though.

The above is intended to be advisory in nature and does not supersede any information contained in the FAR’s or AIM.  Every situation is different and may not apply to every flight.

Posted on

Gotcha! – Hold for release

Did you know that if you receive a “hold for release” IFR clearance at an uncontrolled airfield then decide to depart VFR to pick up your clearance in the air it is a violation? A “hold for release” clearance is just what it says it is, a clearance, and as such you are not authorized to depart without first canceling either your IFR flight plan or clearance.  After, though, you can depart VFR and then pick up your IFR clearance in the air if it is still active.

AIM part 5-2-6. Departure Restrictions, Clearance Void Times, Hold for Release, and Release Times

The above is intended to be advisory in nature and does not supersede any information contained in the FAR’s or AIM.  Every situation is different and may not apply to every flight.

Posted on

Tornado Totals Defenseless Citation X

A tornado in the Midwest struck just one hangar at the airfield where the Citation X was parked, along with an unauthorized camper.  The camper found itself being used as a plus-sized baseball bat and doing its best to beat the heck out of the hapless Cessna.  For some reason, the insurance company decided  that the $20M jet was worth more in parts than to rebuild it.

 

 

 

 

Posted on

Jimmy Franklin and the Jet Waco

Back on the early 2000’s these pictures were taken at the Sussex Airshow in Wantage Township, NJ.  Franklin’s show was spectacular to see anywhere, but I think he took particular joy flying at such a small venue.  He also liked to take full advantage of the  sloping terrain to create breath-taking sight-lines in which he appeared to be flying so low he was going to impact the ground.  He was an unbelievable showman and innovator. His tragic loss in 2005, along with friend and fellow performer Bobby Younkin, was heartbreaking.

Share and Enjoy:
Posted on

FAA recommends new flight rules for Hudson corridor

Rick Day, Senior Vice President for Operations, Air Traffic Organization unveiled new flight safety and operational enhancements for the VFR flight corridor on New York’s  Hudson river in testimony today.  Mr. Day’s statements, made to the Senate Committee on Commerce, Science, and Transportation, Subcommittee on Aviation Operations, Safety, and Security on Aviation Safety, was in response to the fatal mid-air collision of a Piper PA-32 and a Eurocopter AS 350 on August 8th.

Current Hudson Airspace

Current Hudson Airspace

The Task Force, consisting of FAA air traffic and safety experts and air traffic controllers, with assistance from the  Helicopter Association International, the Aircraft Owners and Pilots Association, and the Port Authority of New York/New Jersey, was assigned to make recommendations.  These include mandating pilot rules, standardizing charts, create an entry point from Teterboro, and restructuring the airspace in the following manner:

  • It would establish a uniform “floor” for the Class B airspace over the Hudson River at 1,300 feet, which would also serve as the “ceiling” for the exclusionary zone. This removes some confusing complexity that currently exists.
  • Between 1,300-2,000 feet, aircraft will operate in the Class B airspace under visual flight rules but under positive air traffic control and communicate with controllers on the appropriate air traffic frequency.
  • Below 1,300 feet, aircraft must use a single common radio frequency. Mandatory routes for aircraft flying up and down the river will require them to favor the “right side” of the river (i.e. the east side for northbound traffic and the west side for southbound traffic) to provide horizontal separation as well.
  • Coordination of traffic and handoffs between Air Traffic Controllers at the Teterboro tower, Newark tower, and radar control will be improved.
Proposed Hudson Airspace

Proposed Hudson Airspace

Posted on

FAA Administrator urges professionalism, use of SMS

Randy Babbitt, the FAA Administrator, stressed more cockpit professionalism in the drive for more safety and fewer accidents at US airlines.  In a speech to the International Safety Forum today, Mr. Babbitt stated that the difference between the outcomes of the US Airways Flight 1549 and Colgan Flight 3407 was one of  “textbook greatness, the other a complete inattention to basic details.”

The Administrator was referring to the contrast between the two flights.  The January 15th US Airways flight, which an Airbus 320 was struck by Canada geese after departure from New York’s Laguardia airport and was followed by a successful ditching in the Hudson river.  The other was the February 13th fatal crash of a Colgan DeHavilland Q400 in Buffalo, NY, in which pilot error was largely believed to be the cause.

Babbitt indicated that in addition to a more professional culture, the airlines should better utilize tools and concepts like the Safety Management System (SMS), a set of guidelines and risk management processes designed to increase the safety decision making process. Last month the FAA issued an Advance Notice of Proposed Rulemaking (PDF) concerning the SMS for the airline industry and other aviation operators to adopt.

Posted on

Construction of Spaceport America in NM continues

UP Aerospace SpaceLoft XL

The world’s first purpose-built commercial spaceport is taking shape in New Mexico as development continues on privately funded, civilian spacecraft which will launch from the facility.  Spaceport America, located in Upham NM, 30 miles east of  Truth or Consequences, has been under construction since 2007 with formal ground breaking  ceremonies occurring in June 2009.

The facility will enable the launching of both manned and unmanned systems with pads for vertical launch capabilities as well as a 10,000 foot concrete runway for horizontal takeoffs and landings for spacecraft such as Virgin Galactic’s WhiteKnight2/SpaceShipTwocombination.  Three concrete pads were recently completed for use in NASA’s 2009 Northrop Grumman Lunar Lander Centennial Challenge competition.  Spacecraft will attempt to takeoff and land vertically in a simulated lunar landing.  Several teams are competing for a total of $1.65M in prize money for successfully completing 180 seconds of powered flight followed by a precision landing on one of the pads.

Several launches have occurred at the facility since the project was announced in 2005 with the most recent being a UP Aerospace SpaceLoft XL sounding rocket carrying a New Mexico student payload.  The launch, which occurred on May 2nd, 2009, failed to reach its projected altitude.

Posted on

NTSB issues safety recommendations for Medical Helicopters

Medi-flight Helicopter

Medi-flight Helicopter

The NTSB has issued 15 safety recommendations to various government regulators and helicopter emergency medical services (HEMS) operators following a dramatic increase in accidents.  Among them are the creation of scenario-based pilot training curriculum, installation of  flight data recorders for aircraft, the use of an autopilot in single-pilot operations and use of night-vision equipment for pilots.

According to the NTSB, of the 55 mediflight accidents which occurred in the last 3 years,  of which 41 were helicopters, 29 could have been prevented with the adoption of these recommendations and the others contained in the press release.

As a result of the increase in accidents, a 4-day hearing was conducted in February by the NTSB with testimony from the FAA, the Helicopter Association International (HAI), the Association of Air Medical Services, the Professional Helicopter Pilots Association, the National EMS Pilots Association, Air Methods, and CareFlite.  The following was determined to be the focus of the hearings:

  • Pilot Training
  • Collection of Flight Operations Data
  • Use of Flight Recording Devices and Data
  • Safety Management Systems
  • Weather Information
  • Use of Autopilots or Dual Pilots
  • Night Vision Imaging Systems
  • Reimbursement Rate Structures
  • Federal Policy and Guidelines

The full press release can be seen here

Posted on

Cartercopter in development of personal air vehicle

Carter 2+2 PAV

Carter 2+2 PAV

The research and development company Carter Aviation Technologies of Wichita Falls, TX is slowly developing its 4 place personal air vehicle (PAV) which utilizes technology demonstrated with the CarterCopter Technology Demonstrator (CCTD).  Using the jump ability of an autogyro to get off the ground quickly the aircraft can then use its Slowed Rotor/Compound (SR/C) to travel to its destination at speeds exceeding current production helicopters, then spot-land in areas inaccessable to fixed-wing airplanes.

Jay Carter, CEO and principal designer of CarterCopters, LLC holds over 21 patents in the development of gyrocraft, including one which made the CCTD the first gyrocraft to exceed mu-1 in flight using the SR/C configuration.  As a rotorcraft accelerates forward, the main rotor must travel faster than the relative air around it.  The same air must also go over the retreating blade, causing instability.  This  imbalance in the geometry of the aircraft necessitates  special care in its design.

Pusher rotorcraft like the Sikorsky X2 and the CCTD handle the retreating blade in different ways.  The X2 helicopter utilizes a rigid powered rotor and counter-rotating blades which minimize the angle of attack in the retreating blades, therefore making lift negligible on that side.  Lift of the airframe is then achieved using only the advancing portion of the rotor blades.

The CCTD, as well as the prototype PAV, Carter uses the SR/C concept for an autogyro which actually allows the gyrocraft to travel faster than the advancing blade itself, exceeding mu-1.   This occurs by unloading the aircraft’s lift from the rotor and transitioning it to the wings in this hybrid aircraft.  Cartercopters accomplished this goal with the CCTD on June 17th 2005.

Using the engine to pre-spin the rotor, Cartercopter autogyros are able to jump takeoff using little or no runway.  It then accelerates forward using the rotor as the main lift device, a defining feature of all autogyros.  The rotor’s weight is concentrated in the tips which stabilizes the blades as well as maintaining inertia for jump takeoffs and limited hover.  As the aircraft increases speed, more lift is transferred to the main wings on the fuselage as the rotor is slowed by the oncoming air.  As the aircraft slows for landing, the main rotor is once again loaded to accept more lift as  the vehicle transitions away from the wings to achieve a low speed, low rollout landing.

The 2+2 PAV

The 2+2 PAV is an all new design being developed by Carter to incorporate new technologies for a safer, more economical mode of transportation.  Shown at Airventure 2009 in Oshkosh, WI, the prototype is still under construction but operation is envisioned to begin by pre-spining the rotor, followed by a jump takeoff, reach 210 knots at 20,000 ft and land in a constrained environment. To be built under the FAA’s 51% rule, the Carter company is taking deposits for delivery at a later date.

Carter is also developing a new landing gear technology to decrease or eliminate bounce during a rough landing or a crash.  Using accelerometers controlling valves and hydraulic fluid which changes its viscosity electrically, the PAV will be able to withstand landing impacts in excess of 2000 fps without injury to passengers or loss of aircraft.  The current FAA requirement is 600 fps.

Posted on

DEFCON hacker illustrates flight plan vulnerability

A pilot presenting during the DEFCON conference this month showed how to use fake identities to file flight plans.  As Righter Kunkel explained during the annual convention for hackers, it is easy to provide a AME with false information to obtain a student pilot medical certificate.  Armed with the medical, a person can file false flight plans with ATC.

While this is illegal, it is not going to be a problem until many flight plans are submitted.  If this is done, it can be a big problem in the form of what is called a denial of service attack.  DoS attacks are used to overwhelm the computer servers that are used to process incoming information.  In the case of the ATC’s systems, many of the computers are linked in such a way that if one goes down, it could take down the rest of them.  Radar, communication, and transponder information could all be compromised.

Kunkel explains that he, as a pilot, is trying to get this information out there to highlight the vulnerabilities of the underfunded FAA and increase awareness.